How would you attach a silicone bust to a wall plaque?

SkinnedSculpt

SkinnedSculpt

New Member
Just wondering how one would go about attaching a silicone bust to a (wooden in this case) wall plaque. Im assuming ithe silicone is backfilled with resin/rigid foam but im not sure where to go from there.


Heres an example of what im talking about(from artist Trent Taft)

Chimpanzee.jpg
 
Best idea is to glue the foam itself to the plaque, i'm sure you know that nothing sticks to silicone except more silicone, hotglueing the inner core to the plaque will give it a strong bond, hope that helps
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

_Lee_
Arnold Schwarzenegger bust ?? Where to buy??
Replies
1
Views
177
Too Much Garlic
Too Much Garlic
Scream 31
I have no idea how to make a master mold
Replies
6
Views
673
JRFerreri
JRFerreri
ERen89
Silicone mold options
Replies
19
Views
1,375
DarkHelmet
DarkHelmet
Antonis13
HELP. I need suggestions of how to make an armature.
Replies
2
Views
504
Antonis13
Antonis13
S
Do you use castor oil to seal latex appliances?
Replies
4
Views
756
Michelle6619
M
Back
Top