Did somebody say [THUNDERFURY, BLESSED BLADE OF THE WINDSEEKER]?

Thread starter Fjori
Start date Jul 18, 2018

Fjori

New Member

Jul 18, 2018

No?

Well, I need some help with it anyway! I'm currently working on this 3D printed Thunderfury and I'm almost done with the paint and ribbons. The next step is to add the 'Thunder' part in the middle area. I'm quite new to propmaking, so I'm not familiar with everything that's available.

Thanks for reading!

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.