Spiderman webbing

fettster

Sr Member
Hi All,

I have been mulling over the best way to make the raised webbing for my spiderman costume and i have been fortunate enough to enlist the help of a cnc programmer who will make the molds for me but i dont know the right dimensions.

Does anyone here know what dimensions the movie ones are?

I need to know height, width and the angle of the bevel.

can anyone shed any light?

many thanks in advance

rich
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top