Winter Soldier cosplay build

This moving along very fast and the arm is looking good.
Like George said its your build , however since you are asking for opinions, here is mine.
I would personally fill the star lines since they are not screen accurate.
When I did mine I painted the star on my first arm and then on my second one I used a red vinyl sicker.
Personally I like the sticker better since it wasn't 100 percent permanent.
 
Hmm, where to get cheap knives with sheaths? Original are so expensive.. and 3D models what a saw was not accurate.. Next thing is, I can't go at CON with real knives :-D

Gerber MkII - knife + sheath
Gerber Yari II Tanto - 2x knife + sheath
Benchmade SOCP 176BK -knife + sheath
GI Tanto - sheath

Odesláno z mého Redmi Note 5A pomocí Tapatalk
 
Finger prototype? :p

3ubSaW5.jpg

19S2431.jpg
 
How do you think, he have attached his P226 in thigh holster? Magnets? because those pins are too short to hold something.. or 2 screws in holster grooves?

I think screws are more useful than magnets..

cCaiYxB.jpg
soVhBMp.png
 
Recently we completed my wife's Winter Soldier. For the back harness I used 1000D Cordura (left over), sewn and glued over 2mm foam, and backed with cotton fabric. I copied the design from one of the figurines/ toys.04a967cefbcf8f313eb0783bedf3abf2.jpg
 
Last edited:
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top