Brian Bolland 1:1 Judge Death Helmet and bust

BlindSquirrel

Sr Member
Hey everyone,

About a year ago, I built a Judge Death helmet with the intent of doing a full bust to display it. Long story short, I finally finished him!
JD_Bust-0016.jpgJD_Bust-0017.jpg

The bust is 3D printed and connected to the base with a 1" aluminum tube. The base is also 3D printed but filled with plaster to add some stability.

The uniform is 1/8" EVA foam, painted with Angelus acrylic leather paints.
JD_Bust-0015.jpg

You can see the full build HERE


Models for the helmet and bust are linked at the bottom of the post so you can print out and build your own.

JD_Bust-0015.jpg


JD_Bust-0016.jpg


JD_Bust-0017.jpg
 
Last edited by a moderator:
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top