Boba Fett and FO Snowtrooper helmets

Deetz

Active Member
Recently completed and added to my collection of helmets :) Fett is built from a 3D print and then cast while the Snowtrooper is a one-off 3D printed build. Fett's rangefinder stalk was printed with a hole in the centre so I could run power to the LED's, that's a first for me! :)

first-order-snowtrooper06.jpgfirst-order-snowtrooper05.jpgfirst-order-snowtrooper03.jpgfirst-order-snowtrooper01.jpg

boba_fett01.jpgboba_fett02.jpgboba_fett03.jpgboba_fett04.jpg
 
Nice work. I recently painted up a resin cast Boba Fett helmet for my brother's birthday, and I'm waiting on my ESB Snowtrooper helmet kit.
 
pretty amazing work for 3d prints, that fett is sooo nice. can i ask what 3d models you used?

I made all of the models myself. I still feel that the Fett helm needs tweaking though and will be doing another model. I Recently saw Solo and I want an all red version now as well. :D
 
Almost everyone is getting the stickers on the FO snowtrooper dome wrong. The stickers must be parallel with the eye line and because of the shape of the dome that means the back sticker must be curved to fit properly.
https://c1.staticflickr.com/5/4577/23983716557_58dc994dd3_o.jpg
https://c1.staticflickr.com/5/4584/27072241159_be6672b4c0_h.jpg
https://c1.staticflickr.com/5/4521/38132930744_63000b1e06_o.jpg
https://c1.staticflickr.com/5/4523/27072237779_a8c22ee33e_o.jpg

It's a shame because you seem to have done a nice job with the 3D model.
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top