Kylo Ren Helmet W.I.P

JMSProps

New Member
Im working on a kylo ren helmet which i modelled and 3d printed. This my 3rd kylo ren helmet modelled and is by far the most accurate. I plan on starting molding next week and doing a limited run of finished and kit helmet later this month.

DSC_0107.jpgDSC_0115.jpgDSC_0105.jpg
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top