EVA foam helmets

sgmtino

New Member
I have been working on some EVA foam helmets. Currently have a DR. Fate and Hawkman.
 

Attachments

  • NCM_0494.JPG
    NCM_0494.JPG
    262.2 KB · Views: 685
  • NCM_0499.JPG
    NCM_0499.JPG
    3 MB · Views: 271
  • NCM_0500.JPG
    NCM_0500.JPG
    1.2 MB · Views: 227
  • NCM_0501.JPG
    NCM_0501.JPG
    2.4 MB · Views: 249
  • NCM_0502.JPG
    NCM_0502.JPG
    298.1 KB · Views: 236
  • NCM_0491[1].JPG
    NCM_0491[1].JPG
    1.1 MB · Views: 316
  • NCM_0493[1].JPG
    NCM_0493[1].JPG
    156.5 KB · Views: 273
  • NCM_0495[1].JPG
    NCM_0495[1].JPG
    200.3 KB · Views: 257
Very, very crisp building! Wouldn't have picked them for foam. Great work on hiding the seams. Also curious as to which pattern you used for the Hawkman?
 
On the hawkman I was originally going to modify a wolverine but then decided to use the captain america pattern and make a separate piece for the beak and eyes . The wings are all my own pattern
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top