Subscribe
  1. DARTH SABER's Avatar
    Member Since
    Jul 2002
    From
    Orlando
    Messages
    4,176
    May 15, 2018, 6:43 PM - X-Wing question!!! #1

    So, there are two rods that run along the side X-wing canons and seem to go into the heat sinks. Do they curve down into the heat sinks or do they go straight into the heat sink ring?





    Sent from my iPhone using Tapatalk
  2. Treadwell's Avatar
    Member Since
    Aug 1999
    Messages
    11,077
    May 15, 2018, 8:50 PM - Re: X-Wing question!!! #2

    all the way to the ring.
  3. DARTH SABER's Avatar
    Member Since
    Jul 2002
    From
    Orlando
    Messages
    4,176
    May 15, 2018, 9:05 PM - Re: X-Wing question!!! #3

    Treadwell said: View Post
    all the way to the ring.
    Hole drilled into the ring and inserted





    Sent from my iPhone using Tapatalk
  4. Member Since
    Jul 2017
    From
    Brno, Czech Republic
    Messages
    71
    May 16, 2018, 4:28 PM - Re: X-Wing question!!! #4

    On RED 3 they are not inserted to the ring, they are just touching it. I do not mean it as nitpicking. Just technical note from SS standpoint for the record.
  5. DARTH SABER's Avatar
    Member Since
    Jul 2002
    From
    Orlando
    Messages
    4,176
    May 16, 2018, 4:30 PM - Re: X-Wing question!!! #5

    bigpetr said: View Post
    On RED 3 they are not inserted to the ring, they are just touching it. I do not mean it as nitpicking. Just technical note from SS standpoint for the record.
    Thanks!




    Sent from my iPhone using Tapatalk

Similar Threads

  1. Replies: 4
    Last Post: Jan 30, 2018, 5:26 PM
  2. 1/72 A-Wing question
    johnojodo, General Modeling
    Replies: 36
    Last Post: Feb 15, 2017, 10:19 PM
  3. SS A-Wing question
    Junk Pilot, Studio Scale Models
    Replies: 3
    Last Post: Jan 30, 2011, 9:02 PM
  4. x-wing question
    dansmith, Studio Scale Models
    Replies: 29
    Last Post: Dec 23, 2009, 4:08 PM
  5. X-wing question...
    tgreco, Studio Scale Models
    Replies: 5
    Last Post: Sep 13, 2008, 10:27 AM