How to make T1000 bullet strikes

foldart

Active Member
This is how I did it. I'm pretty happy with the results, but still I'd be interested in alternate methods.






Cut three or four rings of 3mm EVA


T1000Splat_01c.jpg





Cut a wedge out of each ring


T1000Splat_02b.jpg





Glue cut ends to form truncated cones


T1000Splat_03b.jpg





Stack and glue


T1000Splat_04b.jpg





Round edges and scallop the rim


T1000Splat_05b.jpg





Glue base to stack: 3mm EVA with clasp pins


T1000Splat_06b.jpg





Glue central peak (5mm EVA)


T1000Splat_07b.jpg





Spray exterior with paint or Plasti-Dip for more-uniform appearance


T1000Splat_08b.jpg





Seal interior with PVA (Mod Podge, Elmer's)


T1000Splat_09b.jpg





Prime interior


T1000Splat_10b.jpg





Paint interior


T1000Splat_11b.jpg





When I find my heat gun, I'll try curling the edge on the next one. For now, this will do.
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top