Completed reelprops Rebels Vader Helmet

clancampbell

Sr Member
Freshly finished Darth Vader helmet from Rebels....looks like i forgot to wipe off all the polish...DOH! I ground out the nose, which was flat and had lines incised in it, and i resculpted it to be more concave like in the show. :)

Rich IMG_1482.JPGIMG_1481.JPGIMG_1480.JPGIMG_1483.JPGIMG_1484.JPGIMG_1485.JPGIMG_1486.JPG
 
Last edited:
That is awesome!

Can you give a quick breakdown of how you did it?

I'm trying to figure out how to get an even amount of paint inside and outside of the helmet when all i have to work with is my garage :)
 
Looks great!

When I saw the listing for the kit, I didn't understand why the nose was not carved out like you have it.

Sent from my SAMSUNG-SM-G930A using Tapatalk
 
I can’t stop coming back and checking this out... love the rebels Vader. You captured this perfectly


Sent from my iPhone using Tapatalk
 
That is awesome!

Can you give a quick breakdown of how you did it?

I'm trying to figure out how to get an even amount of paint inside and outside of the helmet when all i have to work with is my garage :)

Hi, i know how you feel....i mostly sprayed this in the back yard...

I just used rattle cans....went for nice wet coats as best as i could judge.
Then the same with clear coats, when this was cured, i used Meguires Ultimate compound and microfiber cloths to polish it.

Rich
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top