MY 1977 MPC Vader Tie Fighter

MARK M3

Master Member
RPF PREMIUM MEMBER
My Original 1977 Darth Vader Tie Fighter build. I added missing detail on either side of the window and the "sun visor" thingy in the cockpit. I mixed Tamiya Paints for the color.

Of Course NOT 100% accurate, but with a little TLC, builds up quite nice.

 
Looks great!

Brings back memories of flying it around with the MPC X-wing (I always preferred them over the Kenner toys)

Of course, back then I used sharpies to color the panels black and had no paint on it Someday I will fix mine up. Somewhere along the way I lost the top hatch
 
Last edited:
Good job!

I like that you scribed the panel lines on the main hull, IMHO that was one of their most accurate model at the time followed by the X-wing, the Falcon and the SD were horrible.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top