Interest New OWK AOTC project (Update 8/6 on pg2)

Re: New OWK AOTC project

Any updates on the resin hilt? Not as a project run, as that’s not for sure yet, but in general.


Sent from my iPad using Tapatalk
 
Re: New OWK AOTC project

He's probably busy going over his Luke V2 hilts and shipping them out... that run was HUGE!
 
Re: New OWK AOTC project

Yeah your probably right, not to mention the nightmare he’s having with the v3 shared stunt hilt.


Sent from my iPad using Tapatalk
 
Re: New OWK AOTC project

Sorrry, it's been a while. But here's a quick shot of step 1 a resin printout of the 3d model which will be used as the casting buck.

3D print out products (1).JPG
3D print out products (2).jpg
3D print out products (3).jpg
3D print out products (4).jpg
 
Last edited:
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top