TIE fighter engine parts?

Thread starter baldormoline
Start date Mar 19, 2018
Tags

star wars

baldormoline

New Member

Mar 19, 2018

Hey folks, I am trying to figure out what (if any) model kit parts were used to create the engines on the TIE fighters. The same parts seem to be used for the front sides of the cockpit view port on both the standard TIE and Vader's TIE X-1. The only difference seems to be the tubular openings for the engine lights to seat. Any help on this would be greatly appreciated.

This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.