Got a question you guys maybe could help me figure out. The torpedo launcher area on Moebius' Franklin is not at all accurate. So I have modeled a 3d model replacement I intend to 3d print through shapeways.
However, for it to fit, I need to know the incline on the bulkhead the back attaches too. If we consider the saucer surface 0 degrees, How can I figure out the incline as shown blow? Anyone have any ideas on how to find the exact incline off 90 degrees that it is on the kit? I will then model the back of my 3d launcher to match.
However, for it to fit, I need to know the incline on the bulkhead the back attaches too. If we consider the saucer surface 0 degrees, How can I figure out the incline as shown blow? Anyone have any ideas on how to find the exact incline off 90 degrees that it is on the kit? I will then model the back of my 3d launcher to match.