Looking for DFW Based Mold Maker for Small Project

maddoghoek100

New Member
Im in NYC, but there is a fragile piece i need to have molded that is currently in Dallas Texas. It is a relatively simple sculpture of seated figure (ballpark 5 inc x 6 inch x 8 inch). My instinct is a seamless jacket and mother mold is all it needs. It is a bit fragile air dry tarra cotta clay and many years old so i dont want to risk having it shipped to me to mold.


Does anyone have a recommendation of a Dallas / Fort Worth area mold maker doing commission work? It has been a bit too small a job for folks that i have found so far in the local set design and prop shops.


Any help is always appreciated, please message me with any suggestions. The piece has strong sentimental value and i am looking to preserve it before the tarra cotta eventually becomes too fragile or crumbles.

Mods, feel free to move if this is not the right space.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top