Steampunk Tattoo Machine

badmojo

badmojo

Well-Known Member
Last week I had appointment with my tattoo artist and thought I'd work up a piece for her shop. Basically I started with a length of brass lamp nipple & just rooted through my parts bins until it got to the point where I could call it done.
IMG_20180215_172727_358.jpgIMG_20180215_172727_362.jpgIMG_20180215_172727_370.jpgIMG_20180215_172727_368.jpgIMG_20180215_172727_363.jpgIMG_20180215_172727_383.jpg
 
Man, that's just right on the mark. Not too much, not too little. It would take me half a winter to concept and execute that, I admire your perseverance. I love steampunk machinery that's a little scary. Is that functional or display? Nice work.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Jack Hainsworth
The Time Machine (2002) - References and Proportions
2 3 4
Replies
68
Views
5,486
Jack Hainsworth
Jack Hainsworth
TazMan2000
M60 Machine Gun Prop 3D printable 1:1
2 3
Replies
48
Views
2,719
Bengrim09
Bengrim09
dotails
The Machine(Person of Interest)
Replies
5
Views
447
PicasoX
PicasoX
DinoDino
Just got an Injection Molding machine and looking for Ideas
Replies
8
Views
591
dcarty
dcarty
Snohoman
Working time machine model from 1960 movie "The Time Machine" based on book from H.G. Wells
Replies
4
Views
2,111
rocketeer25
rocketeer25
Back
Top