The Punisher skull plaque

Gabriel P

Well-Known Member
Hello everybody!
A couple of weeks ago I was asked to make a sculpture/plaque of The Punisher skull, it was a very cool project! I slightly stylized the skull but maintained the overall look. I used a mix of synthetic plaster and ceramic powder for the cast of the original sculpture.
Please let me know what you think about it!

IMG_20180219_003048_943.jpgIMG_20180219_002747_858.jpgIMG_20180219_002435_926.jpg
 
Strikerkc I like the sound of step 3 :lol ;)

- - - Updated - - -

I will most probably post an interest thread in the next few days :thumbsup
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top