Blade runner 2049 3d print build.

Lowki13

New Member
Working on my first ever Blade runner kit. Found a seller on etsy doing officer k’s blaster in a 3d print. Figured it would be a good jumping off point. Im gonna document my progress. Here is the basic “kit” printed in two halves it needs a bit of work to get rid of “flash” or “over printing” and the handle feels a bit squished. But it looks pretty decent. The stormtrooper was sent with and is 3 7/8” tall for scale ref.

d5b78fcdb9ea3a7975bb99c25528e06a.jpg



Sent from my iPhone using Tapatalk
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top