Rubies glove with urethane fins?

jayissuperman

Active Member
Anyone ever consider attaching gc5fx fins to rubies doj glove? My gc5fxs are in rough shape do to me splitting them down the middle since they didn't fit right on my suit. I know it sounds crazy but the rubiesgloves do not look half bad. If I were to pull off the fins off of gc5 and put them on what would I use for adhesive regular Super Glue or rubber cement? Wonder if they would be too heavy for the glove?
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top