TFA Data Storage Unit/Map to Skywalker 3D print

Thread starter The14thDr
Start date Jan 4, 2018

The14thDr

Sr Member

Jan 4, 2018

There are a couple of great models for this prop available on Thingiverse, but none of them seem to be as accurate as I’d like (no offence to whoever created the models - I’m just a huge perfectionist!

)

So, using this thread as a reference, I decided to make my own!

If you look at this image, the prop is actually stepped on both sides, rather than just the one side like I originally thought. With this in mind, I created the basic shape of the storage unit.

I then started to add the recessed sections.

This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.