Luke ROTJ Lightsaber v2 3D Print

Superglue and sand for surface prep, prime, detail sand, prime, black base paint, mask the grip off, Molotow through the airbrush, cure, clear coat with Alclad aqua gloss, unmask the grip, Molotow pens on the grip rings, cure, another coat of aqua gloss, mask off aging detail with airbrush liquid frisket and paper mask anything you don't want black, hit with Montana gold spray paint in black, remove all masking, and clear coat final time.
 
It is printing as we speak! Sorry I took so long, school finals have been taking up most of my time. Right now the projected printing time is over 24 hours, so I'll send pics when it's done. sctcarts looks beautiful. I hope mine will live up to that standard:D
 
Last edited by a moderator:
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top