Deagostini millennium falcon build screws HELP!!!

eddiebuild

New Member
would anyone know the size of the screws used to hold down the bunk to the deck?
they are the brass phillips head tapping screws. they look like the brass phillips head machine screws.
 
I did some homework and found screw sizes. it may help some of you. Falcon-Screws-b.jpg
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top