Supreme Leader Snoke wall mount sculpt WIP

SkinnedSculpt

New Member
Im putting my uncle Fester project on hold until I get more comfortable with two part molds so this is my side project until then. There's really only 4-5 decent quality reference images of Snoke and they all seem to have variations so I'm not sure how movie accurate this'll be.

20171207_235143-03.jpeg20171208_234737-01.jpeg20171209_122145-01.jpeg


The sculpt is full scale and its about 70% done still need to detail everything from the eyebrows up. I haven't decided on the plaque/mount design yet, though I'm thinking the first order insignia would work pretty well.
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top