Mjöllnir Build

Wolverine8

Active Member
Hello everyone. Yesterday we started a build Mjöllnir from MCU. This will be for my best friend's (he is the one who help me in this build) son, Emir Thor. (Yes he's middle name is Thor.) These are the foam parts from dying stars heart. :D Cutting parts is finished. Now time for the glue them all.

20171208_002354.jpg 20171209_013443.jpg
 
Here is the almost finished hammer. Time for the a little bit more sanding and after sealing it. Now we can move on to handle part.

20171211_021739.jpg20171211_021753.jpg
 
Now it's look dirty. I don't like how it looks like about handle part. So I decided to make it again. In the photos you see the old one. New one is on it's way.
20171214_191128.jpg20171214_191134.jpg20171214_191141.jpg20171214_191146.jpg
 
Looking really great!
The panel lines are pretty cool, but heres the clincher for me:
HOW DID YOU CUT THE DETAIL LINES SO PERFECTLY?!?!?!?!?
Did you use a laser engraver, an X-Acto knife, etc.?

Jealous ;).
 
Looking really great!
The panel lines are pretty cool, but heres the clincher for me:
HOW DID YOU CUT THE DETAIL LINES SO PERFECTLY?!?!?!?!?
Did you use a laser engraver, an X-Acto knife, etc.?

Jealous ;).

Believe me, just x-acto knife. :D Only, take my time and never be in hurry. That's my secret. And, thank you.

So here is the finished result:

20171217_042359.jpg20171217_042345.jpg20171217_042329.jpg

I hope little fella will be very happy when he see this.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top