My Red Hood Helmet in Progess

Thread starter kevinv
Start date Dec 8, 2017

kevinv

Active Member

Dec 8, 2017

Hey All,
Working on a Red Hood costume and started with the fun part, the helmet. here's a work in progress after a lot of sanding and some bondo. It was printed on my CR-10 with Hatchbox PLA. Detailing and weathering to come.

Will have a build vid over on my channel soon. Cheers

https://www.youtube.com/3dprintedprops

This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.