WIP Cyclops Visor

Comatosed1

New Member
So I finished building my pepakura Cyclops visor and I thought I'd share some progress pics.

20171130_231833.jpg

Here's a shot head on of the build so far. I'm debating on whether or not I should cut out the eye slot now or wait until I apply the resin and harden it up. Any more experienced modelers out there have suggestions? In my head it makes sense to do it now since the paper will be easier to cut but I'm wondering how much more difficult it would be to apply the resin without the added stability that section brings to it.

20171130_231837.jpg20171130_231843.jpg

Here are views from the sides.

Thoughts and opinions are welcome. :)

~Comatosed1
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top