A Few Blade Runner Blaster Questions

Somebody take measurements off one of these kits. and I will take my calpers to my Tomenosuke and we will see.
 
That would be great, guys! Thanks a lot for your help.

I have serious doubt it's spot on to the tomenosuke or the water gun. and just so everything Is on the up and up. I would like to see visual measurements and I will follow with the same.
 
I will start. width is a big problem with the kits mentioned so I will start there. and my calpers are not the best but will suffice.
IMG_20171205_122348.jpg
 
20171205_192034.jpg
20171205_192255.jpg

Sorry about the crapy calipers the digital ones died
Painted the Andrew Foster model is 29mm wide and 28mm unpainted at 100%
The grips need to be printed at 105% to get to Tom size but are the wrong shape around the finger grooves
 
Last edited:
I'm so glad you posted that pic sean, I got 30mm OD 20mm ID pipe to start my Steyr receiver. I'd found 1 image with the 1.1740" measurement and was starting to think I'd got the wrong size again
 
Last edited:
Thanks for all the images, guys! I really appreciate it. I think I will ask hime to upscale the print a little.
 
20171206_163743.jpg20171206_163838.jpg20171206_163915.jpg20171206_164000.jpg
And the printed cylinder on top of a DP one for good measure

My printed shooter is far from finished, The aim was to replace most of the parts with steel or ally but once I realised haw for out the measurements where I decided to build my own, I'm giving my self the next 20 years + to get it done​

20171206_163743.jpg


20171206_163838.jpg


20171206_163915.jpg


20171206_164000.jpg
 
Last edited by a moderator:
Thanks sean any chance you cold do one of the steyr receivers length minus the bit that's drawn back with the cocking lever? and the diameter of the section that blanks off the barrel thread of the steyr receiver ;)


And disregard the random pic that wont leave this post
 

Attachments

  • 20171206_163158.jpg
    20171206_163158.jpg
    4.2 MB · Views: 130
Thanks sean any chance you cold do one of the steyr receivers length minus the bit that's drawn back with the cocking lever? and the diameter of the section that blanks off the barrel thread of the steyr receiver ;)


And disregard the random pic that wont leave this post


This here?

IMG_20171207_135149.jpgIMG_20171207_135530.jpg
 
Second ones spot on, could I get the full length of the steyr bit though


First pics very helpful too​
 
Last edited by a moderator:
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top