StolenBlackMesa
Member
So i am creating this thread in order to have a reason not to quit this project. I am going to attempt to make the ANAD version of Daredevil.
i have the Netflix helmet that I 3D Printed but there is a large gap on either side between the middle and back piece... about an inch and a half wide.
The gap has nothing behind it and shows through directly to my head.
If anyone can suggest something to use to fill the gap then I will be able to make actual progress on this build!
i have the Netflix helmet that I 3D Printed but there is a large gap on either side between the middle and back piece... about an inch and a half wide.
The gap has nothing behind it and shows through directly to my head.
If anyone can suggest something to use to fill the gap then I will be able to make actual progress on this build!
Last edited: