Rebel scanner sensor thingy mabob build and then restart.

PropWeasel

Active Member
RPF PREMIUM MEMBER
Had this project sitting around for a little while and thought I would take a stab at it today. I had the prototype done in foam core, covered it all in ABS plastic then lots o bondo..Then after more research I see that my measurements are off.... it looks a little wide :(---- I may finish it anyway for the shelf of oops ...
23844646_10209886185221158_6659187709452584827_n.jpg23905496_10209886185261159_2501958455979692082_n.jpg24067874_10209886185301160_5636602388134630461_n.jpg23843389_10209886781236058_4858742911663093698_n.jpg
 
Not that I know, but maybe someone else has heard. It definitely looks like either one item or two identical halves. Someone on hear, I think OdiWan72 has done one or was working on it.
 
I ran across his photobucket page while searching for reference pics. Wow he did a great job and would love to know how he made some of the pieces.
 
Quick update.. Holidays and all its a slow go lately. I have been plugging away at it and special thanks to Markus Odiwan for his help.
IMG_0604.jpgIMG_0475.jpgIMG_0606.jpgIMG_0608.jpg
 
just printed out a rough draft of the latch assembly and looks pretty good. only a dozen more parts to render....:) IMG_0717.jpgIMG_0718.jpgIMG_0719.jpgIMG_0720.jpg
 
I believe the circular piece with the three raised circles, were from a pack of small batteries. They were also used on the snowtrooper costumes.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top