Romulan disruptor?

drmoreau

Active Member
I finally got my hands on a 3d printer and was wondering if anyone knew of a decent 3d model of a romulan disruptor pistol?

There's one on thingiverse but it's REALLY boxy and not very accurate at all. The props from the shows were much more rounded. I'm having no luck locating one anywhere online.

Also if you know of other Trek weapons that there are good models of (like a Jem'Hadar polaron pistol, TOS Klingon disruptor, and a few of the harder to find ones) I'd love to print them up and have them on my wall as well.

Thanks!
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top