Please help!!! Utility belt pouches mounting problem

paintknight

New Member
Greetings, I'm Brugo from HK. New to this forum. Recently, I started a kickstarter comic project and a utility belt project ongoing. I finished 2 masters for my belt pouches. Molded and cast several pouches. I even ordered a tactical belt online. However, before the arrival of the belt. Will UHU or superglue or epoxy glue able to secure these black tinted resin cast pouches to the nylon tactical belt? Or any alternative solutions?
I believe its too thin for screws even those small one?
If I m using one of the above glues to secure pouches to the belt, any pre-glue application I have to do before the adhesive application to the belt ?

IMG_7286.JPGFullSizeRender.jpg
 
I think the only secure way in this case is to use some screws. Because the flexibility of the belt no glue will be strong enough for a long time.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top