Replica Kylo Ren Light Saber for The Last Jedi

MBMStudios

New Member
I'm altering a cheap Hasbro kylo ren lightsaber for the premiere of the last Jedi but I can't seem to find enough reference images for the part where the red wire begins and the inner mechanisms at the end of the hilt. if someone has a high-quality version of the hilt or good photos I was wondering if I could get some good photos of those areas, so I can see the detail.

8166c5caba45c8cfd1f9e8d5914ec2a6.jpg
 
I have a suite of Prop Shop (licensed replicas made by the actual prop makers) and Launch Bay photos I have gathered. The inner core part seems pretty consistent, with the exception of it seeming off center in the Wired photos you posted.
a3f0b510b498207ff88fc01825974c12.jpg
6aa33bad40dc6b34f8b37a0292c0458d.jpg



Sent from my iPhone using Tapatalk
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top