Padding Batman cowl

HappenstanceUK

Active Member
Hey guys.

I'm planning on adding some padding to my Batman cowl to get it to fit a bit better and wondered what the best glue is to use to adhere foam to urethane rubber?
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top