New Luke ROTJ v2 3d model comparison and analysis

I don't know if I'm smart enough to do all the finish and paint work and weathering and whatnot - anyone want my spot?
 
I don't know what "what's the ticket" means but if you want my spot at this point, and Anakin will let you do it, it's all you :D
 
Screen Shot 2018-03-16 at 12.28.14 PM.png
"craft sha leathercraft coarse matting beveller 5mm x 6mm"

TB1nwdvHFXXXXasXVXXXXXXXXXX_!!0-item_pic-650x650.jpg
"Japan Craft G605 geometric shader"

It's a 9mm stamp but trimming the edges off (bringing it to 7mm x 7mm) would look pretty darn close in my opinion.

Chunk contenders based off of this shading pattern. Thoughts?
Screen Shot 2018-03-16 at 12.11.40 PM.png
 
Last edited:
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top