Andrew C.
Well-Known Member
Just received www.falcon3dparts.com's new canopy frame upgrade for Revell's 29th scale kit. It's a beautiful look & fit!
Have previously removed some excess plastic for accuracy & fitting of Falcon3Dparts cockpit tub & rebel pilot figure, and was pleasantly surprised to find that the canopy just needed to be dropped in - no fitting necessary. (After removing the printing support rods, that is.)
The printing resolution is very fine and almost unnoticable, but I decided to go over it with some very fine sandpaper to make it absolutely flat. I think after painting the lines probably would have been gone anyway, but wanted to make sure they didn't show up in any pics when doing some extreme close-up photography later.
Have previously removed some excess plastic for accuracy & fitting of Falcon3Dparts cockpit tub & rebel pilot figure, and was pleasantly surprised to find that the canopy just needed to be dropped in - no fitting necessary. (After removing the printing support rods, that is.)
The printing resolution is very fine and almost unnoticable, but I decided to go over it with some very fine sandpaper to make it absolutely flat. I think after painting the lines probably would have been gone anyway, but wanted to make sure they didn't show up in any pics when doing some extreme close-up photography later.
Last edited: