TheArchdude
New Member
Hi everyone, for Halloween this year I thought it would be fun to build the chief of the Knights Who Say Ni costume with a full steel antlered helm. Since this is my first original build design I thought I'd share it with you all.
I SHALL SAY NI TO YOU IF YOU DO NOT FOLLOW THIS THREAD!
From the pictures, it looked to me like the helm was constructed from an upper and lower piece on the front and back, connected in a cylinder with a flat top and a band around the top edge. I started out with some poster board mock-ups for sizing.
I ended up shortening the top pieces by an inch to be only 4" tall. I also made the flanged bits on the top piece a full inch long instead of the half inch on the mock-up.
I SHALL SAY NI TO YOU IF YOU DO NOT FOLLOW THIS THREAD!
From the pictures, it looked to me like the helm was constructed from an upper and lower piece on the front and back, connected in a cylinder with a flat top and a band around the top edge. I started out with some poster board mock-ups for sizing.
I ended up shortening the top pieces by an inch to be only 4" tall. I also made the flanged bits on the top piece a full inch long instead of the half inch on the mock-up.
Last edited by a moderator: