1/2 Studio Scale Dornean Gunship

nicholassagan

Active Member
I was able to source most of the original donor parts in half scales! There were a few parts that required some 3D printing (globetrotter grill, slave 1 stand parts, tirpitz decks)...but otherwise I used:


1/32 P-38
1/100 Slave 1
1/72 F-16


....that's pretty much it!


halfdorn5287.jpg

halfdorn5290.jpg

halfdorn5294.jpg

halfdorn5297.jpg

halfdorn5303.jpg

halfdorn5305.jpg

halfdorn5315.jpg

halfdorn5317.jpg

halfdorn5325.jpg

halfdorn5330.jpg
 
I've always really liked this ship. Fantastic job! What length did it end up being? I need one of these.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top