Emperor Palpatine Cane + Buckle / Broche Set for 3D Print

Spiel

Active Member
Hi all!
4 weeks ago I got a comission request from Diversity3D Props for making a set - Palpatine's Cane + Buckle / Broche.
The main task was to make files for nice 3D printing and the screen accuracy!
We took MR's kit as a reference + few screenshots and custom drawings.
buckle_1.jpgemperorscanedisplay.jpg
Thats the Mk1 version:
2017-09-07 (2).png2017-09-07 (3).png2017-09-07 (6).png2017-09-07 (16).png

- - - Updated - - -

Then we noticed a small cavern at the top right corner...
Mk2...
Palpatine Cane & Cloak Clasp3.jpg
 
Last edited:
So far we're both happy with result and printing Mk2 set.
Here are pics of Mk1 Test-print and chem smoothing.
2017-09-08 13.36.36.jpg2017-09-08 13.35.36.jpg
For future - there'll be Mk3 - Cane curved in the middle, from the front to left.

Thanks for reading!

All comments are welcome and highly appreciated!
 
Hi all!)
Had no time to post updates, sorry guys!
I have made Mk3 - curved cane and will print it within a week or so.
Model looks quite nice, will post print pics a bit later!)
Palpatine_Cane_Mk3.jpg
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top