My WIP Death Eater Mask-

falloutboy

Well-Known Member
RPF PREMIUM MEMBER
Death Eater Mask I'm working on- would love your thoughts. (it is still a WIP)
It will be printed on a resin printer @ 50 micron, then cold cast to resemble the finish on the 3d model. DeathEater Mask2.jpgDeathEater Mask1.jpgDeathEater Mask4.jpgDeathEater Mask3.jpg
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top