Maui tooth necklace help

dms54nyc

Well-Known Member
Looking to make a maui costume for my son. Look for a material to use to make the teeth necklace. With out getting into resins or what not but more or less something to carve into teeth maybe? I guessing maybe a stryene or plastic. Something thatll look legit. Thanks
 
PVC pipe can be made to look exactly like bone or teeth, so that's what I would go with. Polymer clay is another option, but it can be tough because once you bake it you can't do much to clean it up since it's too soft to sand, although it carves about like a bar of soap. But since it's a bit bendy it's a bit safer for something pointy.

-Rog
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top