Farnhaan Prop

I kind of pieced one together...box is a little small, and I’m not sure how to do the text on the bottom, but looks pretty good!
5414DAD9-E518-4828-A946-4833D8D8DDE3.jpeg
 
That looks nice.
I think if the box was made of a thin material with a small, long rectangle was cut out on the lower corner, then put a piece of clear vinyl over the hole,
a light could be placed there and the box could be then covered in a thin, wood grain vinyl.
The name could be carefully cut out of the vinyl with an exacto knife and placed over the lighted rectangle hole.

farnhaan lamp.jpg

farnhaan 2a.jpg
How did you make yours?

Good job.
 
Last edited:
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top