BlastFX / Mini Scope Display (blaster electronics) from TRamp

pwhitrow

New Member
After a long time in development I'm proud to release BlastFX and Mini Scope Kit for order. BlastFX is £95 GBP, Mini Scope Kit is £65 GBP, or £150 GBP if ordered together (shipping included).

Current available weapons: E-11, E-11D, DLT19, DL-44, T-21, EE-3, E-22, F-11D (all included and seleactable).

It will come fully wired and ready to install in your blaster (instructions for installs are not included as there are so many different types of models out there, but advice will be given where possible).

You will need moderate soldering skills to connect the power switch and battery wires. In addition and dependent on your blaster model you may need to hollow bits out to fit the kits.

Ideally use a 3.7v rechargeable Li-Po battery, do not exceed 5v. Batteries are not included.

Videos

BlastFX : https://www.facebook.com/trooperamp/videos/1753634708009867/
The Mini Scope Kit : https://www.facebook.com/trooperamp/videos/1753662984673706/ (the perfect accompaniment to BlastFX)

Please use the "Send Message" button at the top of the Facebook page https://www.facebook.com/trooperamp if you wish to discuss an order.


I'm currently working with some blaster and scope makers with a view to getting these kits installed during manufacture of the weapons, but that's a way off yet.


1.thumb.jpg.126b498b2adb64ca3a3eab1ab717bd73.jpg



2.thumb.jpg.5985af1c4bcf49b78b2c28573f0f0d61.jpg
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top