Mythos Vader 1:12 scale

Thread starter Hemble
Start date Sep 16, 2017

Hemble

Well-Known Member

Sep 16, 2017

#1

Hi All,

Recipe

Vader - is from Bandai and was built straight out of the box and then the joints were glued together and then covered with putty and I added a cape and robe using left over material that I had.

Base - is the stand that comes with the figure and then I added balsa wood around the edges. The rock in the middle is a piece of foam with spakfilla covering it and tehn painted and weathered, the lava is spakfilla and once dry I then painted it with orange/red/yellow/white and then lightly dry brushed it with matt black and once dry I used Woodland Scenics Realistic Water to give a glowing look.

Ron

This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.