MA-MA wrist det

johnojodo

Active Member
MA-MA Det.JPG

Never saw a 3d model for this prop so I thought I'd use my very basic skills to do a close enough one with 123d.
It's only the base model so once I get a chance to print it I can add the extra details (pins, screen and circuit)

I've put it on thingiverse if anyone wants a go
 
20170917_175004.jpg Just a quick test print the bed wasn't leveled so I got some warping but at least I know it'll print.

Once I get back on my feet or I'm at least aloud to stand for long enough to set my printer up I'll print it properly and finish it
 
Thank my grinder! I dropped it the other week and cut my toe off, hence the time to start 3d modelling. You get the V3 flashbang?
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top