Dredd / Star Trek Crossover

IamSteve

Well-Known Member
Hey all!

So i recently got involved with a group on FB who are doing a Dredd/ST cross over and i've done a few designs id like to show off!

First up is the Lawphaser.

lawphaser15.png

I tried to give it an even balance between Lawgiver and Phaser. The mini phaser on the top is removeable.

lawphaser13.pnglawphaser14.png

Ive also done a Communicator, though to be fair its more Trek than dredd, i still quite like it.

communicatorv1_2017-Aug-31_10-01-49PM-000_CustomizedView19960483858.pngcomrender1.pngcomrender2.pngcomprint1.jpgcomprint2.jpg

Ive done one test print of the communicator, found a few issues that ive fixed but over all im pretty happy with it. Note that i didn't remove the supports from the underside of the lid as its only a test print.

Thanks for looking!
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top