This kit has been out of production for a long time but is back with some revisions. Originating from the Coinprop pattern that Steve purchased way back when I had revised it originally to fit better way back when but did not make any changes to the center bar from the original pattern. That made adjusting the pods difficult as Coinprop had the center bar terminate at the pod rather than pass thru the pod body. For the revised kit I extended the bar and made it so I can cast a very hearty 1/4 inch x 1 1/2 inch bar thru the center. This allows for the addition of tweaking system via a 1/4 20 bolt and threaded insert if desired. Some preliminary pics of the build and the new set up.