Cast Resin Side Blades

DarkJedi1500

Well-Known Member
RPF PREMIUM MEMBER
I recently upgraded my black series lightsaber. Initially I had icile lights, but the diameter was smaller than the housing so I decided to upgrade and make cast resin ones. First I upgraded my shop with two new pieces of equipment:

New tools by 2StoryProps, on Flickr

Then made a mold and cast the blades in SmoothCast 326.

DSC_3525 by 2StoryProps, on Flickr

The original icicle light is on the right and the new cast one is on the left.
DSC_3533 by 2StoryProps, on Flickr

DSC02482 by 2StoryProps, on Flickr

The new blades glow much more evenly than the original plastic ones. I am very happy with the results of my new tools.

DSC02486 by 2StoryProps, on Flickr
 
Depending on the run it will be $20. I will let you all know when I post something in the classified section.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top