Sandman0077
Sr Member
It's been almost 3.5 years since I've updated this project in the original Cross Punisher thread. I have been blowing the dust off of my kits and projects that have been stored since I last worked on them.
The cross punisher was water damaged beyond repair, so that will have to be started from scratch again.
I started working on the pistols again, though. I picked up a recast of the Poseidon kit years ago from a member (I believe it was either a Rook copy before he passed away, or a SidKit), and I bought a Colt Commando bb gun to modify based off of the copy.
First things first, I started boring out the slide ports. The copy is on top, Colt on bottom
My plan for this project is to modify the bb gun as far as possible, then cast in resin and finish the mods. Final kits, if I decide to sell any in the end, will be solid casts. That's a ways away from here, though. Wish me luck!
-Josh
UPDATE: 07/25/2017
Worked some more on the upper slide. I'll need to fabricate a new front sight post.
I'll also have to reposition the ejection port farther back. That should be fun!
Cut down the front of the lower frame, cleaned up the front of the slide, and started working on the magazine release.
The cross punisher was water damaged beyond repair, so that will have to be started from scratch again.
I started working on the pistols again, though. I picked up a recast of the Poseidon kit years ago from a member (I believe it was either a Rook copy before he passed away, or a SidKit), and I bought a Colt Commando bb gun to modify based off of the copy.
First things first, I started boring out the slide ports. The copy is on top, Colt on bottom
My plan for this project is to modify the bb gun as far as possible, then cast in resin and finish the mods. Final kits, if I decide to sell any in the end, will be solid casts. That's a ways away from here, though. Wish me luck!
-Josh
UPDATE: 07/25/2017
Worked some more on the upper slide. I'll need to fabricate a new front sight post.
I'll also have to reposition the ejection port farther back. That should be fun!
Cut down the front of the lower frame, cleaned up the front of the slide, and started working on the magazine release.
Last edited: