Sticking dichroic film to pvc

acook59

Well-Known Member
Hey guys,

So i'm working on a project where i'm trying to make a colour shifting chest harness type thing. I want to make it out of thick pvc, say 3mm thick. You can't buy dichroic film that thick so i'll need to stick it to the pvc i think. How do i go about doing that do you think? Is there a way to glue it? How do i go about keeping it nice and smooth, and will it be flexible?

Thanks,
Andrew
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top